Page 1 of 12 Instruction Manual Models: LPP6512 (25”) LPP1112 (43”) For safe operation be sure to read through this instruction manual b
Page 10 of 12 properly, adjust the position of the film rolls on the mandrels. If film is not properly overlapped adhesive may get on the rollers. 7)
Page 11 of 12 5. HOW TO USE REAR CUTTER: Use the Rear Cutter as follows when you wish to cut film after stopping the rollers. 1) Press down on the
Page 12 of 12 9. SPECIFICATIONS: MODEL LPP6512 LPP1112 Maximum Laminating Width 25.6" 44.1" Maximum Laminating Thickness 31.5mil Laminatin
Page 2 of 12 Contents WARNING BEFORE USING YOUR LAMIPACKER: ...
Page 3 of 12 Thank you for your purchase of the Fujipla LPP6512 or LPP1112 laminator. This laminating machine is designed to laminate most common p
Page 4 of 12 SAFETY PRECAUTIONS: For safe operation, be sure to observe following precautions. Installation: 1. Do not install the Lamipacker in a
Page 5 of 12 1. NAMES AND FUNCTIONS: Name of Components 1. Guide Roll 2. Safety Cover 3. Paper Guide 4. Feed Tray 5. Mandrel Holder 6. Heat Roller 7.
Page 6 of 12 Functions 1. READY Lamp (yellow) Yellow lamp glows when the heat roller gets to the desired temperature 2. TEMP C Lamp (yellow) Lamp (y
Page 7 of 12 Motor rotates constantly when this button position is ON (each time you push the button it will be switched into ON/OFF) 9. REVERSE Swit
Page 8 of 12 3) Install the proper mandrel adaptors on the mandrels. Check that the direction of the hooks are pointing in the same direction. (fig.
Page 9 of 12 3. WARMING UP: 1) Plug in the machine and turn on the Power Switch. 2) Raise the Lamination Handle and turn on HEATER Switch. 3) Set th
Kommentare zu diesen Handbüchern